12oz Enamel Flat Bottom Mugs

Mugs can be used for all sublimation and laser printing applications

Hand Wash only

Laser Toner Pressing Instructions:

• 356°F for 250 seconds high pressure
• Check your mug press manual to set the time and temperature
• Put in water to cool then peel.
• Finish by wrapping with a piece of matte finishing sheet, then your silicone mug wrap and press for 15 seconds

 Convection Oven

Temperature: 370-380 °F

Time 7 minutes 25 seconds

• Preheat oven to 370-380° F while preparing your product. • Print and place transfer face down on product. Secure transfer with heat tape. The top and bottom 1/4” to 3/8” may not get enough heat and/or pressure to sublimate consistently. Full bleed image not recommended. • If using Shrink Sleeves, slide heat shrink sleeve over top of the transfer paper. Use the heat gun to shrink the sleeve onto the mug. The larger lip should be outside the wrap. • Shrink one end of the sleeve first to help secure the transfer position on the product. • If using Quick Release Wrap, wrap the product and close by clasping metal ends. • Once oven is preheated, place product in oven and heat for the recommended time. • Submerge the product in water immediately after removing from oven to cool. Remove wrapping after the product has cooled