12" x 24" DynaSub Satin Alm Sheet-Silver

Remove protective film from the face of the metal.
-Before applying the transfer and metal together, dry the transfer as much as possible. This is 
done by laying the transfer on the top of the heating element of the press for roughly 30 seconds. 
Or place the transfer under an open press for 5-10 seconds. This is simply to remove as much 
moisture from the transfer paper as possible before making the actual transfer. Once the transfer 
has been dried, it should be used within a few minutes. If more than ten minutes passes before 
making the transfer, the transfer can be dried again prior to use.
-Using one or more paper towels, place a towel larger than the sheet of metal on the stage of the 
heat press.
-Next, place the metal with the transfer taped to it face down (metal is facing down, transfer facing 
up) on the paper towel.
-Place another paper towel(s) over the transfer and press.
-Using medium pressure, press for 45-50 seconds as needed. Do not press any longer than is 
needed to obtain solid rich colors, especially black. Open press and allow to cool for 10 seconds 
before moving. Metal remains extremely hot. Metal can be moved by handling the transfer paper 
or by using a spatula.                                                                                                                                                                                                     -Multiple pieces of metal can be imprinted at the same time to increase production. Be sure 
the entire area is sandwiched with paper towels. Do not overlap towels next to the face of the 
metal in that this will increase the pressure and alter color. If the image transfers correctly after 
pressing, but the finish of the metal plate appears mottled or hazy, lighten the pressure and/or 
reduce the temperature 10-15 degrees